The starting hard and Idling problem sounds like carb needs cleaning.
Only selling because our son is more interested in horse riding than bikes.
Thread starter jimmies; Start date Mar 18. All going well, done the top end, new bearings and plastics etc.
.
79 MB.
. Copy. All going well, done the top end, new bearings and plastics etc.
The small 50s can also build up carbon in the exhaust port, or the exit end of the muffler.
Also 2016 pw50. . Mar 8, 2005 · I had a '99 PW50 that would start but when you put the switch in the "run" position, it would not rev pass idle.
Jun 10, 2016 · China PW50 Miniky carby (Mikuni copy) To adjust it properly, turn the screw in all the way till it only just start's to get tight, now back it back out 1. On these bikes, the Start position should stop the bike from revving and it should only start in Start, not Run.
No, but it sounds like your coil is going out.
.
Lots of little things to check these guys have already mentioned. Leave the other two single wires connected.
. .
When you shift it up to run, it does not want to rev up and go.
.
. And number to the air filter was not on the carburetor while I was trying to start it. Discussion Starter · #2 · Nov 8, 2001.
Try another new plug. If the connector gets wet, the bike wont run. Pull the spark plug out and kick it over many times to see if fuel comes out the hole. starts but won´t. 75 full turn's. .
.
I've been at the local track for a couple years now. .
Last Thursday the bike ran perfect.
Have put in a new switch block and throttle and choke cables.
This motor was running poorly and stalling repeatedly.
The small 50s can also build up carbon in the exhaust port, or the exit end of the muffler.
Next Morning Starts Right Up.